Includes:

• Flat mount plate with pressed in PEM studs (1/4NC20 thread for all).
• Spacers for mounting Spal 5.2" ATV pusher fan onto outer side of plate.
• Low profile 1/4NC20 nylock nuts for mounting fan.
• Std. profile 1/4NC20 Nylock nuts for mounting oil cooler brackets to plate.
• M6x1.0 hardware hex cap screws and flange hex nuts for mounting oil cooler to provided oil cooler brackets.
• M6x1.0 Studs, nuts, and washers for mounting plate into chassis.

NOTE: B&M Oil Cooler no longer available: Working on prototype with a Mishimoto oil cooler

NOTE: This will not work with a factory mount location air to air intercooler setup.

NOTE: Does not include lines or fittings. For use with customer supplied -10AN lines and fittings.