MegaSquirtPNP Gen 2

Plug-N-Play Standalone Engine Management System

MegaSquirtPNP Model #T8590 Features

Fits several Toyota applications, all USDM with manual transmission:

• 1985-1987 Toyota Corolla AE86 with 4AGE
• 1985-1989 Toyota MR2 with 4AGE
• 1987-1989 Toyota Corolla FWD models with 4AGE
• 1985-1990 Toyota Pickup or 4Runner with 22RE
  

New second generation MSPNP!

Totally redesigned! This new second generation unit runs MS2/Extra sequential code, using the MicroSquirt Module and a lot of new MSPNP-specific hardware. We've added several major improvements over the original. Here's the features of the new model.

Easy to Use and Install!    

• Fully Plug and Play Installation - No wiring required for basic functionality.  Average install time is under 1 hour!
• 4AGE base map is pre-loaded to help your engine start on the first turn of the key (other model base maps included on CD)
• Real time tuning and data logging with a laptop connection
• Supports most aftermarket wideband sensors

Fully Tunable Engine Control!     

• 16x16 Fuel Tables allow high resolution tuning
• 12x12 Ignition Tables
• Multiple Acceleration enrichment strategies
• Closed Loop Idle Speed Control
• Air Conditioner Control
• Up to 4 sequential fuel injector channels with individual trim tables (minor wiring change required to run sequential, 4AGE only)
• Onboard peak and hold drivers support both high and low impedance injectors - No external ballast resistor is needed!
• Allows removal of stock airflow meter

Advanced Feature Set (Included!)

• 12x12 Air Fuel Ratio Target Tables for use with wide band O2 sensor for precise tuning and table trim.
• Built-in 2-step rev limiter / launch control with flat shift
• Real time barometric correction
• Internal 4-bar MAP sensor reads up to 44PSI of boost
• Overboost protection
• Closed loop boost control (Requires DIYAutoTune.com EBC solenoid kit)
• Knock sensor input with adjustable sensitivity
• Headphone output for knock sensor - listen for knock while you tune!
• Table switching input. Change fuel and spark maps on the fly for different fuels, nitrous activation, etc.
• Input for flex fuel sensor - switch between E85 and gasoline on the fly!
• CANBus connector allows interconnection of other MegaSquirt-compatible devices for additional functions (EGT Input, Automatic Transmission Controller, Additional Sensors.....the possibilities are limitless!

What you get in the box:

• MegaSquirtPNP T8590 ECU

• MSPNP RS232 serial tuning cable, 6' (USB adapter sold separately, if needed)

• Tuning Software and Documentation CD

• 6' Vacuum Hose for MAP Signal and 'T' fitting

• Four Screws for ECU mounting